MP - Raptor Cut Service

Services offered on the MP Model Slides this includes 9/40/45 models

• Single Color Cerakote is required with this service

• This service is for the gen 1 or 2 (3.6”-4.5”) model slides.

• The number of raptor cuts on each side is dependent on the length of slide. The shorter 3.6 model slides only have 3 on each side.

• When adding to the cart you will be asked what optic model are we cutting for and about rear iron sight placement. If we are relocating the rear iron sight, please make sure you select “yes” to the dovetail option before adding to the cart.

• This service includes the disassemble and reassembly of your slide.

• When adding an optic cut to your slide suppressor height sights will be required, regardless of model of optic being used. If you are looking for a co-witness setup.

• If you are using any of the following optics the optic and screws must be provided at the time of work (Holosun EPS/EPS Carry/Viper/Venom/Depta Point Pro/RomeoZero)

• If you are using any of the following optics the optics they must be cut to the rear of the slide removing the factory rear iron sight. Make sure to Select “Yes” on dovetail if we are relocating the rear iron sight to the front of the optic (Trijicon RMR/SRO/Holosun 407a/407C/507C/508T/Vortex Viper/Vortex Venom/Leupold Delta Point Pro)

**This service is not offered on the Front Serration/ Full sized 5” / EZ model or 45 Model Slides

** We will not install XS Sights. If you provide these, we will bag your factory sights and ship back the new sights. This will allow you to install them without removing the factory sights.

• We recommend you review current samples of the colors we provide. These will be the exact colors you can select during checkout. Those samples can be found here>>> COLOR SAMPLES <<<